Skip to Content
Brand Name: DMI

Aluminum Ball Spline Driveshaft, 16 Spline Yoke, WP Style Swivel Rear

Part #: DSA-9000-22.00
DMI's aluminum driveshafts have changed the game. With limited horsepower applications it is critical to take advantage of anything and everything. DMI's aluminum driveshafts showcase the unmatched commitment of DMI to think different, innovate and provide the most advanced components on the planet!
  • Available in 22" OAL for midgets and 27.5" OAL for sprint cars
  • 40" engine setback sprint car uses 27.5" OAL shaft
  • 7000 Series hard anodized aluminum
  • 16 spline front yoke 
  • 32 spline rear to accept WP Style 20 tooth swivel ball
  • Recommended for applications below 700 HP 
  • Includes installed swivel ball, rubber boot and retaining ring
$ 439.50 $ 439.50

  • Driveshaft Length
Terms and Conditions
30-day money-back guarantee
Shipping: 2-3 Business Days

Instructions


Winters style driveshafts do not require a spring in the u-joint assembly. Make sure the rubber boot and snap ring are slid over the shaft. Liberally grease the swivel coupler in the rear and the front and rear splines of the shaft with Bulldog Blood 777 Extreme Pressure Spline Grease. Slip the shaft into the u-joint assembly if the engine is in the car. With rear out of gear spin female housing until shaft and coupler splines are aligned. Install the shaft and rubber boot into the coupler using the DMT-1950 installation tool. Once the shaft and boot are properly seated use a 90 degree internal snap ring pliers to install retaining ring. The installation tool may be used to ensure proper seating of the ring in the groove. Visually inspect when completed.